There are five sections under Chasis: Suspension, Alignment and Tires, TPMS, Steering, SCCM and Brakes.
Alignment & Tires:
- Clear Applied Offset
- Calibrate steering Column
- Offset Drive Test - it will show whether alignment is centered or not.
- Reset Learned Tire Values -
1. Alignment and Tires
Actual applied offset
On top of left side, you will see Actual applied offset
Clear Applied Offset
- To clear applied offset.
- Runs ODIN routine PROC_EPAS_ESP_CLEAR-ANGLE-OFFSETS to clear applied offset.
Offset Drive Test
- it will show whether alignment is centered or not.
- Runs ODIN routine TEST-SELF_EPAS_X_STEERING-CENTER-OFFSETSERVICE to perform an offset test drive.
- Purpose of this action is to check if alignment has been disturbed significantly after a suspension repair.
Calibrate steering Column
Reset Learned Tire Values
- Runs ODIN routine PROC_VCSEC_X_TPMS-ERASE-AND-AUTOLEARN to reset estimates after tire rotation or replacement.
Live steering wheel Angle + force applied on the steering wheel.
- You could see on right hand side
2. TPMS
3. Steering
Steering column vitals
Calibrate steering Column
- Runs ODIN routine PROC_STEERING_COLUMN_CALIBRATION to calibrate the steering column.
Steering rack vitals
4. SCCM (Steering Column Control Module)
This panel allows the user to check each function / button related to the SCCM. For instance, when pushing the park brake button, the « P » on the screen will become yellow.
This confirms the button is working properly.
5. Brakes
Source: Tesla
