What might need to do to fix/start the car after accident
Fireman's Loop
- Check if safety/Fireman's loop is cut
Pyro Fuse
- Check if pyro fuse is blown up
- Might need to replace Pyro Fuse
- After replacing pyro fuse, car should be able to start/move
HV Plug Under Seat
- Check if plug under the rear seat is plugged in.
Load Shed
- Clear Post Crash Load Shed
VCFRONT
- Might need to Clear VCFRONT (Crash Flag)
- Might need to replace VCFRONT
- In some cases, it is possible to reset via Service Mode
- In some cases, it might need Toolbox
Replace new VCFRONT
If you install new VCFRONT. You have to reinstall firmware.
Actions - VCFRONT - TESTRESET_ VCFRONT - Run
Low Voltage Battery
- Might need to replace low voltage battery
- Check Low voltage battery is connected properly
Contactors Status
Check if contactors are open. If its open, car will not support low voltage battery and it will drain low voltage battery. If you need support how to check and how to close it. Please contact us.
Airbag
You need to replace Airbag if the airbag exploded. You need to order Airbags.
Support/Questions
Need support to start the car. Please contact us Whats App +49(0)15226242038
Software reinstall
Pyro Fuse
- Check if pyro fuse is blow up.
- Is it car moving/starting.
Load Shed
- First you might need to clear load shed
VCFRONT
reset/replace VCFRONT.
- Might need to replace VCFRONT, if you can not clear reset
Power Supply
Need to support with power supply.
Get connected car to WiFi
do software reinstall (Firmware update)
Low Voltage Battery
Later replace/work/repair on Low Voltage battery.
FAQ
Service mode is not loading (just spinning)?
Did you perform all needed repair/reset/replacement parts?
Service Mode might not load if VCFRONT is in Load Shed Mode.
Car is not moving/starting after accident
